iPECS UCP - 2.19 Call Re-Routing (CRR)

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
59
3.3.3.8 PTT (Push-To-Talk) Group Access – PGM 119
Each iPECS Phone is assigned to receive PTT announcements from any combination of the nine
PTT groups. Note remote stations and stations not assigned to a group will not receive PTT page
announcements including All PTT group page. As a default, all stations except remote stations
are assigned to group 1.
PROCEDURE:
PTT GROUP ACCESS
ENTER STA NUMBER
1. Press the [PGM] button and dial 119.
100-110 PTT GRP ACC
PRESS FLEX_KEY (01-10)
Use the dial-pad to enter a station range (Ex. 100~110). For
a single station, enter the same number twice.
The first 10 Flex button LEDs indicate assigned zones.
Press the desired Flex button to toggle Push-To-Talk group
assignments,
LED On: station receives announcement
LED Off: station does not receive PTT announcement
Flex button 10 assigns group 0, all groups.
Press the [Save] button to store the PTT group data.
3.3.3.9 Preset Call Forward – PGM 120
This assignment allows an external or internal call to initially ring at a station and forward to a pre-
determined destination. Preset Call Forward can be assigned separately for internal and external
calls forwarding for all calls (Unconditional), Internal Busy, No-Answer or DND, or External Busy,
No-Answer or DND. Calls can set as Preset Forward to a Station, Hunt group, System Speed dial
for Off-net, or Station ICR.
For the “Transfer to Mail-Box” enter the Station Group number of the Voice Mail group (external
VM, VSF or Feature Server Voice Mail group). This will permit other iPECS IP Phone and LDP
users to transfer a call directly to the desired user‘s Voice Mail-Box.
PROCEDURE:
CALL FWD PRESET
ENTER STA RANGE
1. Press the [PGM] button and dial 120.
100 – 110 STA PRES FWD
CONDITION CHOICE (F1 –F8)
Use the dial-pad to enter a station range (Ex. 100~110). For
a single station, enter the same number twice.