iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
396
4.4.5.29 CO Call Rerouting - PGM 252
Selecting CO Call Rerouting will display the CO Call Rerouting data entry page. Enter a valid
Index range and click [Load] to enter Call Routing data. Click [Save] button after changing Value.
Figure 4.4.5.29-1 CO Call Rerouting
CO Call Rerouting establishes routing for CO/IP calls with a specified caller id on CO/IP Lines
from a specified group. The rerouting sends calls out over another CO/IP Line or group, a
network destination, a DISA call or to another station. The incoming CO group and compare digits
determine if the call should be rerouted and the destination is determined by the CO code and
Telephone number, which is dialed when the incoming group and compare digits are matched.
The routing type determines if the call is routed normal (N/A) or if the call is routed over a network
or employs DISA.
Example CRR chart
Index Incoming CO group Compare Code CO Code + Tel number Routing Type
0 1 454 88005123456 N/A
1 2 456** 8901123456 N/A
2 1 42*555 9123456 N/A
3 5 353 8901123456 NET Type
4 5 401 DISA Type
- Index 0: If an incoming call on a CO/IP Line from group has digits “454” then seize CO 5
and send digit 123456.
To Next Page
Loading...
