iPECS UCP - LCR Digit Modification Table - PGM 222

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
175
3.3.9.1.3 LCR Digit Modification Table — PGM 222
Using the index determined from the analysis of the LCR Leading Digits Table PGM 221, the
dialed number is modified in accordance with the Digit Modification Table and sent over the
CO/IP group assigned for the index.
Digits of the dialed number can be deleted based on the “Removal Position (RP)” and “Number of
Remove digits (NR)” and a digit stream can be inserted in the resulting number. Counting from
the first dialed digit, the Removal Position defines the location of the digit where removal begins
and, NR defines the number of digits to remove. The “Add Digit Stream” is then inserted in the
resulting number at the digit position assigned by the Add Position entry. The resulting number is
then dialed over the CO/IP path assigned. If the assigned path is not available, the “Alternate
DMT index” is used to determine the number and CO/IP path to be used.
Table 3.3.9.1.3-1 provides the displays, descriptions and entry ranges for the Digit Modification
Table.
PROCEDURE:
DMT TABLE
ENTER DMT BIN (00-99)
1. Press the [PGM] button and dial 222 and enter DMT bin
number (Ex.55).
55 A: . . . . . . . . . . . . . . . . . . . .
RP01 NR00 AP01 CG01 AD ..
Using the dial pad enter the desired Digit Modification Table
index.
Press the Flex button (1~6) for the desired Table entry, refer
to Table 3.3.9.1.3-1.
Use the dial pad to enter the desired Digit Modification Table
data, refer to Table 3.3.9.1.3-1.
Press the [Save] button to store the data entry.
Table 3.3.9.1.3-1 LCR DIGIT MODIFICATION (PGM 222)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
DMT 55 ADDED DGT
. . . . . . . . . . . . . . . . . . . . . . . . . .
This entry defines the digit stream to insert in
the number after digits are removed. Digits
0~9, ‛*’, ‛#’, and special characters:
[HOLD]: timed Pause
[DND]: Dial tone detect
[FLASH]: Billing station number
25 digits
2
DMT 55 REMOVAL POSITION
(01-12) : 01
This entry defines the position of the digit
where removal is to begin, starting with the
1
st dialed digit (01).
01~12 01
3
DMT 55 NUM OF REMOVE
DIGITS (00-12) : 00
This entry defines the number of digits to
remove starting at the “Removal Position”.
00~12 00
4
DMT 55 ADD POSITION
(01-13) : 01
This entry defines the position in the number
(after digits are removed) where the Add
Digits are inserted.
01~13 01
5
DMT 55 CO/IP GROUP
(01-21) : 01
This entry defines the CO/IP Group that the
system will attempt to use for the call.
01~21 01
6
DMT 55 ALT INDEX
(00-99) : . .
This entry defines an Alternate Digit
Modification Table Index to use if no path is
available in the assigned CO/IP Group.
00~99