iPECS UCP - ICM Tenancy Group Attributes (Pgm 125); ICM Tenancy Group - PGM 125

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
64
3.3.3.14 ICM Tenancy Group – PGM 125
Stations can be assigned to an ICM Tenancy group under Station Attributes II PGM 111, button
17. Up to 15 Tenant groups for eMG80 and up to 32 for eMG800 can be defined. Each group is
configured to allow or deny placing intercom calls to stations in other groups and an Attendant
station can be defined for each group. The Attendant will receive “dial 0” calls and controls
Day/Night mode for the Group.
PROCEDURE:
ICM TENANCY GROUP
ENTER GRP NUMBER (01-15)
1. Press the [PGM] button and dial 125.
ICM TENANCY GRP 01
F1:ATD F2:ACCESS
Use the dial-pad to enter the group number (Ex. 01)
Press the desired Flex button; refer to Table 3.3.3.14-1.
For Attendant assignment, use the dial-pad to enter the
station number of the Group Attendant.
To assign accessible ICM Tenancy groups for the group, the
Flex button indicates the current Tenant group access.
Press the Flex.
Buttons to toggle Group access settings.
LED ON: group access allowed
LED OFF: group access denied
Press the [Save] button to store the data entry.
Table 3.3.3.14-1 ICM TENANCY GROUP ATTRIBUTES (PGM 125)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
ICM TENANCY GRP 01
ATD: . . . .
Attendant station for the ICM
tenancy group. ATD. Receives dial
‘0’ calls and controls Day/Night
mode.
STA No -
2
ICM TENANCY GRP 01
PRESS ACCESS GRP(1-15)
ICM Tenancy groups allowed
access to the selected group.
eMG80:01-15
eMG800:01-32
GROUP 1