iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
225
If “Installation Period” or the color of SW Maint. is GREEN, system software can be upgraded.
Major version upgrade is possible in “Installation” or “Maintenance” Period but Minor version
upgrade is possible in “Warranty” Period. In other states, both upgrade and downgrade are not
allowed.
License State Display
First LED : SW maintenance
Second LED: Temporary License
Third LED: T-Net (eMG & UCP) / Redundancy (UCP only)
Note)
1) To turn off the alarm, Administrator can set ‘Alarm Enable’ to OFF in System Data >
Alarm Attributes (163) > Alarm enable: OFF. For more information, refer to Alarm
Attributes.
2) To turn off the alarm on Phone, press ‘Alarm reset’ PGM code *565 to stop. It’s a one-
time thing. Please check the exact alarm reset code in Flexible Numbering Plan
(106~109) because the code is different according to the numbering plan.
The following figure is SW Maintenance state for SMB. System Alarm (Attenant alarm & E-mail
notification) occurs once 30 days before expiration and daily during 7 days before expiration.
SW Maintenance State
If the system goes to the limited service mode, the station COS is changed to 7.
To Next Page
Loading...
