iPECS UCP - In-Room Indication - PGM 183

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
138
Table 3.3.6.20-3 SYSTEM TIMERS III (PGM 182)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
10
FLEX DID TMR(100ms)
(01-99): 30
The system will receive DID digits for
this timer. After the timer expires, the
system will use the last 2 to 4 digits
received as DID digits.
01~99
(100msec.)
30
11
WAKE UP FAIL TMR (sec)
(00-99): 20
Provide wake up fail indication to
attendant according to this timer.
00~99
(1 sec.)
20
12
PREPAID WARN TMR (sec)
(00-99): 00
Prove warning tone when run out of
prepaid money if this timer is not zero.
00~99
(1 sec.)
00
13
FAX DETECT TMR (sec)
(01-20): 10
It is maximum fax tone detection time
to deliver FAX call to fax destination.
1~20
(1 sec.)
10
14
AUTO PAUSE TMR (sec)
(000-255): 000
IPCR Mute function will be released
by this auto pause released timer.
0~255
(1 sec.)
0
3.3.6.21 In-Room Indication – PGM 183
The Supervisor Station can set the In-Room Indication to all members in the same Group up to
10 bins can be programmed, and each bin has (at most) 20 members excluding the Supervisor.
PROCEDURE:
IN ROOM INDICATION
ENTER BIN NO (01-10)
1. Press the [PGM] button and dial 183.
IN ROOM INDICATION
F1:SUPERVISOR F2:MEM
Use the dial-pad to enter the desired bin number.
Press the desired Flex button; refer to Table 3.3.9.6-1.
Press the [Save] button to store the data entry.
Table 3.3.6.21-1 In-Room Indication (PGM 183)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
IN ROOM INDICATION
SURERVISOR : STA 100
Assigns Supervisor station.
2
STA 100 MEM
101 …. …. ….
This entry assigns stations as
members.