iPECS UCP - Page 152

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
137
Table 3.3.6.20-2 SYSTEM TIMERS II (PGM 181)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
16
ERROR TONE TMR(1sec)
(005-180) : 030
Error Tone Timer 005~180
(1 sec.)
30
17
HOWLING TONE TMR(1sec)
(000-180) : 030
Howling Tone Timer 000~180
(1 sec.)
30
18
NOTIFY PLAY DELAY(1sec)
(01-99) : 10
When VM notification call uses LCO,
system will treat the call as the
answered after this timer and play the
new message prompt.
1~99
(1 sec.)
10
19
SHORT MODEM TMR(1sec)
(01-60) : 10
If {Short modem} of a SLT is ON, the
SLT maintains the modem mode for
this time.
01~60
(1 sec.)
10
Table 3.3.6.20-3 SYSTEM TIMERS III (PGM 182)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
SLT HOOK BOUNCE(100ms)
(01-25) : 01
This timer determines the duration the
system considers an actual state
change in the hook-switch and not a
spurious contact bounce.
01~25
(100msec.)
01
2
SLT MAX H_FLASH(100ms)
(01-25) : 07
This timer sets the maximum time an
SLT user can depress the hook-
switch for a Flash signal.
01~25
(100msec.)
07
3
SLT MIN H_FLASH(10ms)
(000-250) : 010
This time sets the minimum time an
SLT user must depress the hook-
switch for a Flash signal.
000~250
(10 msec.)
010
4
STA AUTO RLS TMR(sec)
(000-300) : 060
For an internal call, the system will
return a station to idle if the call
remains unanswered for this duration.
000~300
(seconds)
060
5
UNSUPER CONF TMR(min)
(00-99) : 10
This timer determines the duration of
an “Unsupervised conference” before
the station is recalled or the
conference is dropped.
00~99
(minutes)
10
6
PRIME LINE TMR(sec)
(01-20) : 05
This timer sets the delay (no action
duration) for delayed Prime Line
operation.
01~20
(seconds)
05
7
WINK SIGNAL TMR(10ms)
(010-200) : 010
This timer sets the duration of the
“Seize Acknowledge Signal” (Wink)
sent to the PSTN on a DID line.
010~200
(10 msec.)
010
8
EN-BLOC I_DGT TMR(sec)
(01-20) : 05
When an ISDN Line is assigned to
send digits En-block, PGM 143-button
3, the system will send a dialed digit if
the user dials “#” or this timer is
expired.
01~20
(seconds)
05
9
DTMF DURATION TMR(10ms)
(04-99) : 10
This timer establishes the duration of
the DTMF tone sent on an analog CO
Line.
04~99
(10 msec.)
10