iPECS UCP - Page 151

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
136
Table 3.3.6.20-2 SYSTEM TIMERS II (PGM 181)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
3
VSF USR RECORD(sec)
(000-999) : 060
This timer sets the maximum duration
allowed for the User Greeting in the
system’s basic Voice Mail.
000~999
(seconds)
60
4
VSF VALID USER MSG(sec)
(0-9) : 4
This timer sets the minimum duration
allowed for a voice mail message in
the system’s basic VSF Voice Mail.
Messages shorter than this period are
not stored.
0~9
(seconds)
4
5
DOOR OPEN TMR(100ms)
(00-99) : 20
This timer sets the minimum contact
closure time required to activate the
contact assigned as a door open
contact.
00~99
(100msec.)
20
6
ICM DIAL TONE TMR(sec)
(001-255) : 010
If a user goes off-hook on the
Intercom and takes no action for this
timer, the user will receive error tone.
001~255
(seconds)
10
7
INTER DIGIT TMR(sec)
(01-20) : 05
This timer sets the maximum allowed
time between user dialed digits. At
expiration, the user will receive error-
tone.
01~20
(seconds)
05
8
MSG REMINDER TONE(min)
(00-60) : 00
An iPECS Phone user will receive
periodic reminder tones of a message
waiting at intervals based on this
timer.
00~60
(minutes)
00
9
PAGE TIME OUT TMR(sec)
(000-255) : 015
Determines the maximum duration of
a page after which the caller and
Page Zone are released.
000~255
(seconds)
15
10
PAUSE TMR(sec)
(1-9) : 3
A Timed pause of this duration is
used in Speed Dial and during other
automatically dialed digits sent to the
PSTN.
1~9
(seconds)
3
11
SOFT AUTO RLS TMR(sec)
(01-30) : 10
When a Soft Key is used on the
iPECS Phone, after expiration of this
timer, the display will return to the
previous display.
1~30
(seconds)
10
12
VM PAUSE TMR(100 msec)
(01-90) : 30
When the system sends a “Pause” to
Voice Mail using In-band signals, the
Pause interval is defined by this timer.
Not available in the USA.
1~90
(100msec.)
30
13
VSF CUT ERR TMR(1 SEC)
(01-90) : 00
To cut error tone in VSF message
that is leaved in a station.
1~90
(1 sec.)
00
14
UNUSED
Unused.
15
EMERGENCY RETRY TMR
(00-99) : 00 SEC
System try to make emergency call
according to the CO access
rule/Prefer CO/CO group if system
could not seize predefined emergency
Co line within this timer.
00~99
(1 sec.)
00