iPECS UCP - Station User Login

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
549
4.4.14.2 Station User Login – PGM 443
Selecting the Station User Login will display the User Login Registration data input page. Enter
an index range then click [Load] to modify Station Login data. For convenience, the copy, paste,
and drag is available to enter or modify data. Click [Save] button after changing Value.
Enter Index Range
: eMG80: 1-140 / eMG800: 1-1200 / UCP: 1-2400
Figure 4.4.14.2-1 Station User Login
Station User Login configures User credentials for registration of iPECS UCS clients and initial
registration of SIP phones. A station must register with the system each time it is connected to
the system. The ID and password are assigned along with other characteristics of the remote
station such as Zone, desired station number, country code, Language and a remark can be
defined. The iPECS UCS Client can be configured as link-paired station by assigning the same
Desired-Number as a registered desktop iPECS LIP Phone.
Note for the UCS Client, the UCS Standard Client Login, PGM 446, may be employed in place of
PGM 443 as a single point to configure the client information.
Table 4.4.14.2-1 STATION USER LOGIN
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Registered
Number
Station number registered to the station, displayed only after
registration.
Station number
Device Type This filed is indicated what kind of device type is.
ID
The User Login ID must be entered for registration
12 Characters
Password
The User Login password must be entered for registration.
12 digits