iPECS UCP - Network Basic Attribute

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
511
4.4.10.1 Network Basic Attributes - PGM 320
Selecting Network Basic Attributes will display the Network Basic Attributes entry page. Click
[Save] button after changing Value.
Figure 4.4.10.1-1 Network Basic Attributes
Table 4.4.10.1-1 NETWORK BASIC ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Net Enable
For operation, the Networking function must be enabled here.
Note a license is required.
OFF
ON
OFF
Net Retry Count
Not used.
00-99 0
Net CNIP Enable
The name of calling station is sent to the called iPECS UCP.
CNIP is shown in the LCD of the called party’s station.
OFF
ON
ON
Net CONP Enable
The name of the connected station is sent to the calling iPECS
system. The CONP is shown in the LCD of the calling party’s
station.
OFF
ON
OFF
Net Signal Method
Network signaling can be sent in the Facility or User QSIG
supplementary service message.
UUS/
Facility
Facility
Net Cas Enable Not used.
OFF
ON
OFF
Net VPN Enable Not used.
OFF
ON
OFF
Net CC Retain Mode
This field defines the Network signaling retain mode for CCBS
service.
OFF
ON
OFF
Net IP Auth.
For operation, the Networking function must be enabled here.
Note a license is required.
OFF
ON
OFF