iPECS UCP - Station COS

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
281
4.4.2.6 Station COS - PGM 116
Selecting Station COS will display the Station COS data input page. Enter a valid station range
and click [Load] to enter the Station COS data. Use the check mark to indicate which attributes
to modify; data for checked attributes is stored by clicking [Save] button.
Figure 4.4.2.6-1 Station COS
In case of PGM 116 is in condition of limited service mode due to License issue, the default value
is 7 for all COS type.
All stations are assigned a Class-of-Service (COS), which determines the ability of the user to dial
certain types of calls, refer to Table 4.4.2.6-1. Separate COS assignments are made for Day,
Timed and Night Mode operation. As a default all stations are assigned with a Station COS of 1
for all modes, no restrictions. The station COS interacts with the CO Line COS to establish overall
dialing or Toll restrictions. This interaction and the resulting restrictions are given in Table
‘Station/CO COS’.
Long distance calls are determined by the first dialed digit (“0” or “1”) and the number of digits
dialed. If the first digit dialed is a LD code, default “0” or “1”, or, if the number of digits dialed
exceeds the assigned LD digit counter in ‘System Data SMDR Attributes section’, the call is
considered a Long Distance call and appropriate restrictions applied.
Table 4.4.2.6-1 STATION COS
STATION RESTRICTIONS
1
No restrictions are placed on dialing from the station.
2
The assignments in Exception Table A are monitored for allow and deny numbers.
3
The assignments in Exception Table B are monitored for allow and deny numbers.
4
The assignments in both Exception Tables A & B are monitored for allow and deny numbers.
5
The leading digit dialed cannot be a Long Distance code, default “0” or “1”, and further denied/allowed
based on Exception Table C.
6
The leading digits dialed cannot be a Long Distance code & digit count cannot
exceed the LD digit counter, default 7 digits, and further denied/allowed based on
Exception Table C.