iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
516
4.4.10.6 Network Numbering Plan - PGM 324
Selecting Network Numbering Plan Table will display the Network Numbering Plan Table data
entry page. Enter a valid table index and click [Load] to enter the Network Numbering Plan data.
For convenience, the copy, paste, and drag is available to enter or modify data. Click [Save]
button after changing Value.
Figure 4.4.10.6-1 Network Numbering Plan Table
The Network Numbering Plan establishes the digit strings that make-up the numbering plan and
associated routing for each Plan code.
Table 4.4.10.6-1 NETWORK NUMBERING PLAN TABLE
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Network Type
The type or use of the code is defined as directed to the
PSTN (carrier) or a Networked system.
NET / PSTN NET
Numbering Plan
Code
This field defines the digits, 0 ~ 9 that make up a Network
Numbering Plan code. An ‘*’ will represent any digit. To
assign the code for the stations in another system, enter
the common station number digits followed by “#”.
Max. 16 digits
(Include * and #)
Networking CO
Group
The Numbering Plan CO Group indicates the Network
CO/IP Group that is used for the connection. A ‘00’ entry
is an internal net station number.
00-24
CPN ISDN
Information
When an ISDN Line is used to place a network call, the
CPN ISDN Information and the network Number are used
as the Called party number.
Max. 16 digits
CPN Information
When a VoIP channel is used to place a network call, the
CPN used is the IP address associated with the VoIP
channel.
1: 00 CPN INFORMATION 01
2: 00 CPN INFORMATION 02
3: 00 CPN INFORMATION 03
Enter IP address
Setup Wait
Response Time
Networking call-setup failure timer when there is no
proceeding message from network (i.e. IP-Network is
0, 3~15 Sec. 0
ALT Speed Bin
Should the Network path fail, the system can place the
call over an alternative path using a System Speed Dial
eMG80:2000~4999
To Next Page
Loading...
