iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
543
4.4.13.7 Zone RTP Relay Group – PGM 440
Selecting the Zone RTP Relay Group returns the RTP Relay ON/OFF data input page. Enter the
desired Zone and Group numbers and click [Load] button to assign Zone characteristics. Click
[Save] button after changing Value.
Figure 4.4.13.7-1 Zone RTP Packet Relay Groups
While it is strongly recommended that a Zone only have a single RTP Relay Group, up to 15
Groups can be assigned to a Zone. Devices in an RTP Relay Group should have common
requirements for packet relay use. In some situations, it may be necessary to implement packet
relay to groups in a Zone. Note that when “if Need” is assigned as the RTP Relay Rule in the
Zone Attributes, assignments here are ignored.
To Next Page
Loading...
