iPECS UCP - Page 557

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
542
Table 4.4.13.6-1 ZONE ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
identifying the device Zone, i.e. Branch1.
Display time zone
The time & date displayed at the station are based on the
time zone selected or the system time
Time zone,
System time
System time
Max Total Inter
Zone Connections
This parameter may be used to limit the number of
maximum Inter Zone connections. When this value is set
to 0, there is no limit on the total Inter Zone connections.
eMG80:0-140 (0:
No limit)
eMG800: 0-1200
(0: No limit)
UCP: 0-2400 (0:
No limit)
0
Max Outgoing CO
Calls
This field may be used to limit the number of outgoing
CO/IP calls from the Zone. When this value is set to 0,
there is no limit on the number of outgoing CO/IP calls.
eMG80:0-74 (0: No
limit)
eMG800: 0-600 (0:
No limit)
UCP: 0-998 (0: No
limit)
0
Zone MOH Assign A Music source can be assigned so that calls to this zone.
Refer to Sys Hold,
Internal music
External Music
VSFMOH,
SLT MOH1~5,
VSF MOH2~3
Refer to Sys
Hold
Emergency Call
Notify Station
Assigns the destination station for Emergency Call
Notification.
Station number
Emergency Call
Notify 2
nd
Station
This field assigns a secondary station to receive
notification of an Emergency call from a device in the
Zone.
Station number
DCOB Fault Notify
Station
This field assigns the station to receive notification of a
DCOB (Digital CO Board) fault.
Station number
SIP Registration
Fault Notify Station
This field assigns the station to receive notification of a
SIP Trunk registration fault.
Station number
Daylight Saving
Usage
If option is "System DST mode", the zone will follow the
system DST mode (System Date &Time (178)).
If option is "OFF", the zone will not apply the Daylight
Saving Time.
System DST mode,
OFF
System DST
mode