iPECS UCP - Network Basic Attribute (Pgm 320); Network Basic Attribute - PGM 320; NETWORKING DATA - PGM 320 to 324

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
194
3.3.10 NETWORKING DATA – PGM 320 to 324
3.3.10.1 Network Basic Attribute – PGM 320
PROCEDURE:
NET BASIC ATTRIBUTE
PRESS FLEX KEY (1-8)
1. Press the [PGM] button and dial 320.
Press the Flex button 1~8 for the desired setting, refer to
Table 3.3.10.1-1.
Use the dial-pad to enter the required data.
Press the [Save] button to store the new data.
Table 3.3.10.1-1 NETWORK BASIC ATTRIBUTE (PGM 320)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
NET ENABLE
(1:ON/:OFF) :OFF
Enable Networking function 0: OFF
1: ON
OFF
2
NET RETRY COUNT
(00-99) :00
Not used. 00-99 00
3
NET CNIP ENABLE
(1:ON/:OFF) :ON
The name of calling station is sent
to the called system between
iPECS eMG. CNIP is displayed at
called party stations display based
on the programming.
0: OFF
1: ON
ON
4
NET CONP ENABLE
(1:ON/:OFF) :OFF
Reserved for future usage. 0: OFF
1: ON
OFF
5
NET SIGNAL METHOD
(1:FAC/:UUS) :FAC
Select the information element type
for QSIG supplementary service
message.
0: UUS
1: FAC
FAC
6
NET CAS ENABLE
(1:ON/:OFF) :OFF
Not used. 0: OFF
1: ON
OFF
7
NET VPN ENABLE
(1:ON/:OFF) :OFF
Not used. 0: OFF
1: ON
OFF
8
NET CC RETAIN MODE
(1:ON/:OFF) :OFF
Not used. 0: OFF
1: ON
OFF