iPECS UCP - Network Supplementary Attributes

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
512
4.4.10.2 Network Supplementary Attributes - PGM 321
Selecting Network Supplementary Attributes will display the Network Supplementary Attributes
entry page. Click [Save] button after changing Value.
Figure 4.4.10.2-1 Network Supplementary Attributes
Table 4.4.10.2-1 NETWORK SUPPLEMENTARY ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Net Transfer Mode
Call Forward and Transfer over the network employs
the selected Rerouting or Join method
REROUT/
JOIN
REROUT
TCP Port for BLF
The TCP/IP port for BLF message packets to BLF
Manager is defined.
9500-9999 9500
UDP Port for BLF
The UDP port for BLF message packets to BLF
Manager is defined.
9500-9999 9501
BLF Manager IP
The IP Address of BLF Manager server is required
when iPECS UCP is configured with eMG systems in
the Network.
0.0.0.0
Duration of BLF State
The system sends BLF messages to the BLF
Manager at intervals of this timer.
01-99
(Sec.)
10
Multicast IP
The multicast IP address for BLF service.
0.0.0.0
Net Trans Recall timer
When a call forward or transfer does not receive a
response for the Network system, the call recalls the
transferring party at expiration of this timer.
001-300
(msec)
10
NET Reroute CO
Group
If an outgoing SIP call receives no response after
expiration of this timer, the call is rerouted to the
alternate CO line.
eMG80:0~20
eMG800:0~200
UCP:0~200
BLF Service Usage BLF Manager support must be enabled for use. OFF, ON ON