iPECS UCP - External Voice Mail Group Attributes

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
419
Table 4.4.6.3-3 RING GROUP ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Destination destination, bypassing the hunt process. “Forced
Forward”, below, must be enabled.
group,
VSF Announcement,
Sys. Speed
Forced Forward
Dest Usage
Calls to a Station group may forward directly to a defined
destination, see above “Forced Forward Destination” when
Forced Forward is enabled for the group.
OFF
ON
OFF
Ring group
indication
When a station calls a Ring Group, DSS/BLF buttons
assigned for the calling station will flash and muted ring is
received.
OFF,
Mute,
Burst
Mute
Figure 4.4.6.3-4 External Voice Mail Group Attributes
Table 4.4.6.3-4 EXTERNAL VOICE MAIL GROUP ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Wrap-Up Timer
After terminating a group call, the VM port will be
maintained in a busy state for the duration of the
Wrap-Up timer.
000~900
(seconds)
002
Put Mail Index
For external analog Voice Mail groups, an index to the
Voice Mail Dial Table that contains the “Put Mail” dial
code.
1~4 1
Get Mail Index
For external analog Voice Mail groups, an index to the
Voice Mail Dial Table that contains the “Get Mail” dial
code.
1~4 2
Station Group Type
The type of Station Group process applied to the SLT
ports connected to the VM can be assigned as
Circular or Terminal.
Terminal/
Circular
Terminal