iPECS UCP - T-NET Control Contact

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
530
4.4.12.5 T-NET Control Contact -PGM 334
Selecting T-NET Control Contact will display the data entry page. Enter the T-NET range from the
T-Net LM Attributes then click [Load] to modify the data. Click [Save] button after changing Value.
Enter T-NET Range
: eMG80: 1-15 / eMG800: 1-32 / UCP: 1-100
Figure 4.4.12.5-1 T-NET Control Contact
Each LM incorporates relay contacts that can be employed as a Door Lock Release. The contact
activates a third party Door Lock Release mechanism activated by dialing the Door Unlock code
at a local station.