iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
232
5. To check the function, click Function Base button in the left frame and User Function List
and you will see the following figure.
You can enable or disable the function by checking each function and then click the save
after setting Value. Also move to each step by clicking [Next] button or [Previous] button.
To delete the user function, click Maintenance at the top of window and then click the Function
Program -> User Function Management. Check the desired function to delete and click [Delete]
button.
Deleting Function
To Next Page
Loading...
