iPECS UCP - Prefix Dialing Table; Prefix Dialing Table Attributes

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
438
4.4.7.7 Prefix Dialing Table - PGM 206
Selecting ISDN Prefix Dialing Attributes will display the Prefix Dialing Table Attributes data entry
page. For convenience, the copy, paste, and drag is available to enter or modify data. Click [Save]
button after changing Value.
Figure 4.4.7.7-1 Prefix Dialing Table Attributes
Prefix Dialing Table. With this table, three features can be supported.
1. Analog CO Call Charge with NPR metering.
2. SIP direct dialing with no wait inter-digit timer.
3. ISDN Prefix Call – ISDN en-block Dialing with Prefix Call Setup.
If first some digits (up to 8 digits) of outgoing dial number are matched with Prefix Code of each
table, this table can start work. By each Co-line (PGM 142 – F20), Table ID (0-6) can be set. This
table ID (PGM 142 – F20) is associated with PGM 206 – each table ID.
Table 4.4.7.7-1 Prefix dialing Table Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Prefix Code Enter the Prefix code. (Max 8 digits)
Max. 8 Digits
(Include * and #)
Table ID Enter Table ID (0-6). 0 means NOT used. 0-6 0
Min Digit
Select the minimum dial digits (00-30).
00-30
0
Max Digit
Select the maximum dial digits (00-30).
00-30
0
Number Of Type
Select Number of Type (0~6).
Unknown/International/National/Network
Spec/Subscriber/Abbreviated /Reserved.
Unknown/
International/
National/
Network spec/
Subscriber/
Abbreviated/
Reserved
Unknown