iPECS UCP - Call Rerouting Attributes (Pgm 252); CO Call Rerouting - PGM 252; Crr Table Attributes (Pgm 252)

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
191
3.3.9.14 CO Call Rerouting – PGM 252
System can reroute incoming call to CO. If called number matched with compare digits of Table
252, the call are routed to Rerouting number.
PROCEDURE:
CRR ATTRIBUTE
PRESS FLEX KEY (1-3)
1. Press the [PGM] button and dial 252.
Press the desired Flex button; refer to Table 3.3.9.14-1.
Use the dial-pad to enter the appropriate data.
Press the
[Save]
button to store the data entry.
Table 3.3.9.14-1 CALL REROUTING ATTRIBUTES (PGM 252)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
ENABLE CRR
(1:ON/0:OFF) : OFF
Enable CRR 0: OFF
1: ON
OFF
2
INIT CRR
PRESS [Save] KEY
Initialize all data
3
CRR ATTRIBUTES
ENTER BIN NO (000-169)
If PGM 252-BTN1 is set ‘ON’,
BTN3 is available.
(Ex. enter the bin number 000)
000-169
CRR TABLE 000
PRESS FLEX KEY (1-4)
Press the desired Flex button,
refer to Table 3.3.9.14-2
Flex button 1-4
Table 3.3.9.14-2 CRR TABLE ATTRIBUTES (PGM 252)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
CRR 000 COMPARE CO GRP
GRP NO (01-20) : 01
Enter group number for compare
digits in incoming.
01-20 01
2
CRR 000 RECEIVE DGTS
. . . . . .
Enter receive digits. ..
3
CRR 000 CO+TEL NUMBER
. . . . . . . . . . . . . . . . . . . . . . . . . .
Enter co group (or individual co,
access co) plus telephone number.
..
4
CRR 000 TYPE
...
N/A : press digit ‘0’
NET TYPE : ‘1’ for transit out
DISA TYPE : ‘2’ for using DISA
0-2 N/A