iPECS UCP - 2.77.2 Lost Call Recording

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
215
3.3.16 VIRTUAL TRACE DIP-SWITCH — PGM 452
The Virtual Trace Dip-switch is used to enable and disable traces for various functions as
defined in Table 3.3.16-1.
PROCEDURE:
VIRTUAL TRACE DIP SW
PRESS FLEX KEY (01-22)
1. Press the [PGM] button and dial 452.
To enable trace, press the desired trace button 1-9. The Flex
button LEDs indicate trace setting, On/Off, press the desired
Flex button to toggle Trace Enable,
LED on: trace enable
LED off: trace disabled.
To enable selected trace settings, press the [Save] button.
Table 3.3.16-1 VIRTUAL TRACE DIP-SWITCH (PGM 452)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
1
VIRTUAL TRACE DIP SW
CALL TRACE : (OFF)
‘Call Trace’ is enabled for output. 0: OFF
1: ON
OFF
2
VIRTUAL TRACE DIP SW
VOIP TRACE : (OFF)
VoIP Trace is enabled for output. 0: OFF
1: ON
OFF
3
VIRTUAL TRACE DIP SW
HTTP TRACE : (OFF)
HTTP Trace is enabled for output. 0: OFF
1: ON
OFF
4
VIRTUAL TRACE DIP SW
MULTICAST TRACE : (OFF)
Multicast Data (normally registration
data between MPB and local mode
device) Trace is enabled for output.
0: OFF
1: ON
OFF
5
VIRTUAL TRACE DIP SW
CTI TRACE : (OFF)
CTI Device Trace is enabled for
output.
0: OFF
1: ON
OFF
6
VIRTUAL TRACE DIP SW
RAW DATA TRACE : (OFF)
Detailed Data Trace is enabled. 0: OFF
1: ON
OFF
7
VIRTUAL TRACE DIP SW
MPMP TRACE: (OFF)
MPB to MPB Data Trace is enabled
for output.
0: OFF
1: ON
OFF
8
VIRTUAL TRACE DIP SW
CPU RE TRACE: (OFF)
CPU Redundancy Data Trace is
enabled for output. It is not used.
0: OFF
1: ON
OFF
9
VIRTUAL TRACE DIP SW
MISU/VMIU TRACE:( OFF)
MISU/VMIU Trace is enabled for
output.
0: OFF
1: ON
OFF
10
VIRTUAL TRACE DIP SW
DSP TRACE (OFF)
DSP Trace is enabled for output. 0: OFF
1: ON
OFF