iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
299
4.4.2.18 Station Personal CCR Table – PGM 128
Selecting Station Personal CCR displays the Station Personal CCR Table input page. Enter a
valid Station range and click [Load] to enter the Station Personal CCR Table data. Click [Save]
button after changing the type or value.
Figure 4.4.2.18-1 Station Personal CCR Table
Table 4.4.2.18-1 STATION CCR Table
ATTRIBUTE DESCRIPTION RANGE DEFAULT
1-0 Destination
Digit dialed by outside caller.
A destination type and value can be programmed by dialed digit. 14
kinds destination is available.
… NA
CCR One Digit
When ON, the system will analyze the first digit received only,
additional digits dialed by the caller are ignored.
OFF
ON
OFF
CCR Table Usage
If this option is ON, CCR table can be activated.
If this option is OFF, CCR table is not available, instead of that, dialing
digits by outside caller can be recognized as DISA dialing.
ON
OFF
OFF
*Button Used As
* can be used as the following:
System Numbering Plan
Replay Greeting
Access Mailbox
Leave Message Immediate
Refer to
Description
Leave
Message
Immediate
To Next Page
Loading...
