iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
291
4.4.2.14 Station Timers - PGM 123
Selecting Station Timers will display the Station Timers input page. Enter a valid Station range
and click [Load] to enter the Station Timers data. Use the check mark to indicate which attributes
to modify; data for checked attributes is stored by clicking [Save] button.
Figure 4.4.2.14-1 Station Timers
Certain timers can be assigned on a station basis. Available timers, description and valid inputs
are given in the below table.
Table 4.4.2.14-1 STATION TIMERS (PGM 123)
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Station Forward No
Answer Timer
This timer set the duration that the station will ring
prior to Ring-No-Answer Forward. This setting
affects both manual and ‘Preset Call Forward’ and
overrides ‘Call forward No Answer timer in System
timer of System data’.
000-600
(seconds)
000
Cut Off Timer
Allowed length of CO/IP calls when station is
assigned ‘Call Time restriction in Common
Attributes of Station data’.
00-99
(minutes)
00
To Next Page
Loading...
