iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
133
3.3.6.19 Multi Language – PGM 179
The VMIU and VMIB support multiple languages; up to six languages may be supported
simultaneously. Once the prompts are downloaded to the VMIU/VMIB, the caller receives the
Language selection announcement for DISA and CCR calls as well as proceeding a Hunt Group
guaranteed announcement or DID error announcement. The language selection announcement
will only affect the language prompts enabled for use.
PROCEDURE:
SET SYSTEM MULTI LANG
ENTER SEQ NO (001 -300)
1. Press the [PGM] button and dial 179 (e.g. enter 015).
eMG800 sequence number range is 0001-2890.
SET 015 SYS MULTI LANG
PRESS FLEX KEY (1-6)
Select Flex button,
Button 1: N. AMERICA Prompt Usage
Button 2: UNKNOWN Prompt Usage
Button 3: UNKNOWN Prompt Usage
Button 4: UNKNOWN Prompt Usage
Button 5: UNKNOWN Prompt Usage
Button 6: UNKNOWN Prompt Usage
N.AMERICA Prompt Usage
(1:ON/0:OFF) : OFF
Us the dial pad to enable or disable the desired language
prompts.
Press the [Save] button to store the data entry.
3.3.6.20 System Timers I to III - PGMs 180-182
A number of timers can be assigned to control and affect many features and functions of the
system. Refer to Table 3.3.6.20-1 to Table 3.3.6.20-3 for a description of the timers and the input
required.
PROCEDURE:
SYSTEM TIMER 1
PRESS FLEX KEY (01-22)
1. Press the [PGM] button and dial:
180 for System Timers I
181 for System Timers II
182 for System Timers III
Press the Flex button for the desired Timer; refer to Table
3.3.6.20-1 to Table 3.3.6.20-3.
Us the dial pad to enable or disable the desired language
prompts.
Press the [Save] button to store the data entry.
Use the dial-pad to enter the desired Timer data, refer to
Table 3.3.6.20-1 to Table 3.3.6.20-3.
Press the [Save] button to store the Timer data entry.
To Next Page
Loading...
