iPECS UCP - Redundancy Attributes

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
572
4.4.19.1 Redundancy Attributes – PGM 502
Selecting Redundancy attributes will display the page shown. Click [Save] button after changing
Value.
Figure 4.4.19.1-1 Redundancy Attributes
The Redundancy attributes enable redundancy and activate “Geographical” redundancy.
Table 4.4.19.1-1 Redundancy Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
CPU Redundancy
usage
When redundancy is employed, this field informs the master
UCP that a redundant UCP is available.
OFF
ON
OFF
Change Active UCP By
Power Fail
When power fails, the active UCP is changed to the standby
mode and the standby UCP becomes active.
OFF
ON
OFF
Geographical
Redundancy
Geographical redundancy permits remote location of the
redundant UCP modules.
OFF
ON
OFF