iPECS UCP - 2.20 Call Transfer; 2.20.1 Call Transfer, Outside Line

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
60
PROCEDURE:
F1:S F2:H F3:SPD F4:ICR
UNCONDITION : ….
Press Flex Button for the desired type of forward:
1. Unconditional
2. Internal Busy
3. Internal No Answer
4. External Busy
5. External No Answer
6. Transfer to Mailbox (destination must the VM Group).
7. Internal DND
8. External DND
ENTER FWD STA NO.
UNCONDITION : STA ….
Select Flex button for the Destination type:
1. Station
2. Hunt Group
3. System Speed Bin for Off-net
4. Station ICR
Use the dial pad to enter the value associated with the
selected type:
For Station & Net Station, enter station number,
For Hunt Group, enter Station Group Number,
For System Speed Bin for Off-Net enter Speed bin
number.
Press the
[Save]
button to store the data entry.
3.3.3.10 Idle Line Selection – PGM 121
When a station goes to an off-hook condition (lifts handset or presses [SPEAKER] button), the
system normally provides intercom dial tone. In place of the dial tone, the station can be
programmed to access a CO Line, CO/IP Group or call a Station or Station Group as described in
Table 3.3.3.10-1. The Idle Line Selection (Prime Line) can be either immediate or delayed after
going off-hook. The immediate/delay selection is based on the Hot/Warm assignment in Station
Attributes III Prime Line PGM 113, button 7 and System timers PGM 182, button 6.
PROCEDURE:
IDLE LINE SELECTION
ENTER STA RANGE
1. Press the [PGM] button and dial 121.
100-110 IDLE LINE
NOT ASSIGNED (1-7)
Use the dial-pad to enter a station range (Ex. 100~110). For
a single station, enter the same number twice.