iPECS UCP - Initialization - Pgm 450

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
211
3.3.14 INITIALIZATION — PGM 450
The system has been pre-programmed with certain features, which are based on the default
database. The defaults are loaded into memory when the system is initialized. The system should
always be initialized when installed or the database is suspected of being corrupt. The system
can be initialized manually during installation, refer to the iPECS eMG Hardware Description &
Installation Manual.
This program allows all or any of several distinct portions or the database to be initialized,
returned to default.
PROCEDURE:
INITIALIZATION
PRESS FLEX KEY (01-17)
1. Press the [PGM] button and dial 450.
Select a Flex button to initialize the desired data, refer to
Table 3.3.14-1.
Press the [Save] button, the selected data is initialized and
confirmation tone is received.
Table 3.3.14-1 INITIALIZATION DATA (PGM 450)
BTN DISPLAY REMARK
1
INITIALIZATION
FLEX NUM PLAN
It will initialize numbering plan.
2
INIT STATION DATA
STATION DATA(ENT STA RNG)
It will initialize station attributes for selected stations.
3
INIT COL DATA
COL DATA(ENT COL RNG)
It will initialize CO line attributes for selected CO lines.
4
INIT COL DATA
SYSTEM DATA
It will initialize system attributes.
5
INITIALIZATION
STATION GROUP
It will initialize hunt attributes.
6
INITIALIZATION
ISDN TABLES
It will initialize ISDN related attributes.
(MSN/Flexible DID, COLP, DID conversion)
7
INITIALIZATION
SYSTEM TIMER
It will initialize system timer attributes.
8
INITIALIZATION
TOLL TABLES
It will initialize toll tables.