iPECS UCP - Flexible DID Destination (Pgm 231)

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
183
Table 3.3.9.7-1 FLEXIBLE DID CONVERSION (PGM 231)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
6
TABLE 001 USE ICLID
(1:ON/O:OFF) : OFF
A DID Conversion Table index can
be assigned to employ ICLID
routing, section 3.3.8.4.
0: OFF
1: ON
OFF
7
TABLE 001 AUTO RING TBL
(00-16),16:N/A) : 00
A DID Conversion Table Index can
be assigned to employ an Auto ring
mode table, section 3.3.9.9.
00-16 00
8
TABLE 001 MOH : (00-10)
REFER TO CO HOLD(00)
A Music source is assigned so that
calls to the destination receive
audio from the source in place of
ring-back tone.
00-10
(00:
Refer to CO
Hold
01: INT Music
02: EXT Music
03: VSF MOH
04: SLT MOH1
05: SLT MOH2
06: SLT MOH3
07: SLT MOH4
08: SLT MOH5
09: VSF MOH2
10: VSF MOH3
Refer to CO
Hold
9
TABLE 001 RING TONE
(00-16, 0:N/A) : 00
Ring tone of destination is followed
this ring tone value.
2 digits.
00~16
00
Table 3.3.9.7-2 FLEXIBLE DID DESTINATION (PGM 231)
TYPE DESCRIPTION
01
Route to a Station
02
Route to a Hunt Group
03
Route with System Speed Dial
04 Route as PBX Transfer with System Speed Dial
(Flash then dial speed dial digits)
05
Route to VSF AA Announcement
06
Route to VSF AA Announcement and disconnect
07
Route to a Networking Station
08
Conference Room
09
Internal Page
10
External page
11
All Call Page
12
Voice Mail Box Group
Voice Mail Box Station
13
ICLID Ring Assignment Table
14 Company Directory
(USA Only)
15 Record VM Greeting
(USA Only)