iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
257
incremented from 1 as each terminal device is registered. At registration, station numbers
increment sequentially with the index and are assigned starting at Station 100 for eMG80 and at
Station 1000 for eMG800/UCP. The Station Numbering Plan allows the station numbers to be two
(2) to eight (8) digits in length as long as the number of digits in the Station numbers is the same.
You can set the CID password to click “Go to Setting” button. After clicking it, you will move to the
following PGM 162 and set the CID password, and then save CID password to mark tick on the
save box and click the [Save] button.
Setting CID Password directly
To Next Page
Loading...
