iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
507
4.4.9.19 Dummy Dial-Tone Digit Table
Selecting Dummy Dial-Tone Digit Table will display the Dummy Dial-Tone Digit data entry page.
Click [Save] button after changing Value.
Figure 4.4.9.19-1 Dummy Dial-Tone Digit Table
When digit conversion is programmed, the CO line is seized after digit conversion is completed
and therefore user cannot hear the CO dial tone from PX until completing digit conversion. For
this case, a dummy dial tone can be programmed. Pressing one of pre-programmed digits (‘0–9’,
‘*’, ‘#’, X’) will provide CO dial tone to the user regardless of CO line seizure.
To Next Page
Loading...
