iPECS UCP - UCS Standard Client Attributes

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
558
4.4.15.4 UCS Standard Client Attributes – PGM 447
Selecting UCS Standard client attributes will display the UCS standard client attributes input page.
Enter the UCS Client index then click [Load] to modify the client data. Use the check mark to
indicate which attributes to modify; data for checked attributes is stored by clicking [Save] button.
Enter UCS Client Index
: eMG80: 1-32 / eMG800: 1-200 / UCP: 1-200
Figure 4.4.15.4-1 UCS Standard Client Attributes
The UCS Client can be allowed or denied access to several features as described in Table
4.4.15.4-1.
Table 4.4.15.4-1 UCS Standard Client Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Allow Scheduled Dial
Allows Scheduled Dialing from the client.
OFF/ON
ON
Allow Flexible Button
Allows the user to access Flex buttons on the UCS Client.
OFF/ON
ON
Allow Step Call Allows access to the step-call feature by the UCS client. OFF/ON ON
Allow Call Memo Allows the UCS Client access to the Call Memo feature. OFF/ON ON
Allow Call Pickup
Permits the UCS Client use of the Direct and Group Call Pick-
up features.
OFF/ON ON