iPECS UCP - 2.7.8 Event Messages; 2.7.9 Group Mail Box

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
28
3.3.2.4 Flexible Station Numbering Plan -PGM 105
Each LDP Phone, iPECS IP Phone and SLT is assigned a Sequence Number during the
registration process. The station Sequence Number is a 3-digit number starting at 001, which is
incremented as each terminal device is registered. At registration, station numbers increment
sequentially with the Sequence Number and are assigned starting at station 100 for Sequence
Number 001. The Station Numbering Plan allows the station numbers to be Three (3) to eight (8)
digits in length.
PROCEDURE:
001 002 003 004
100 101 102 103
1. Press the [PGM] button and dial 105.
001 002 003 004
… … … …
Use either of the two methods below to change the station
number associated with a Sequence Number. Note pressing
the [SPEED] button twice clears all station number
assignments.
The [VOL UP] / [VOL DOWN] buttons are used to view
the next/previous 2 station Sequence Numbers.
Range entry:
Using the dial-pad, enter a station number range (first &
last station number). The two station numbers must be of
the same length, 2~8 digits. The range assignment
begins with the first station number shown by the LCD
and continues to the end of the entered range.
Single entry:
4.1 Press Flex button 1~4 to select the desired Sequence
Number from the two shown by the LCD.
4.2 Dial new station number.
Press the
[Save]
button to store the new station numbers.