iPECS UCP - Page 410

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
395
Table 4.4.5.28-1 System Call Routing Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
EXT Page/
All Page/
VM/
ICLID Table
Scenario Priority
Each scenario can be assigned a priority.
The highest priority scenario meeting the
criteria is used to route the call.
0-9
(Highest priority)
Scenario Active
A scenario must be active to be employed. If
not active the scenario is ignored.
ON
OFF
OFF
Scenario VMID
A Voice Mail Id can be associated with the
scenario for routing to a Voice Mailbox.
Voice mail ID
Scenario COS
If DISA is active for the scenario, the COS
can be assigned for the call.
0-11
(COS level)
0
Scenario DISA Active
The scenario can employ DISA for the
incoming call routing.
OFF/
ON
OFF
Scenario ICM Group
The scenario can route calls to a specific
Tenancy group.
eMG80:0-15,
eMG800:0-32
UCP:0-100
0
Scenario Zone No.
A zone can be assigned so that only CO
calls to a CO/IP Line in the Zone will route
based on the scenario.
0-32 0
Scenario Start CO and End CO
This field defines a range of CO/IP Lines that
will employ to the scenario.
eMG80:0-74,
eMG800:0-600
UCP:0-998
0
Scenario Group: this is used for
scenario group by attendant.
Scenarios can be group allowing the
Attendant to select a group of scenarios to
route calls.
eMG80: Group
number(01~15/
00: unused)
eMG800: Group
number(01~32/
00: unused)
UCP:0-100
0
Zone Holiday
A Zone can be assigned for routing calls
using the scenario during Holiday periods
defined for the Zone.
0-32 0