EasyManua.ls Logo

iPECS UCP - Page 286

iPECS UCP
689 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
271
Table 4.4.2.2-1 Common Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
handset and speaker with the handset microphone active and
speakerphone microphone OFF.
Enable
Override Privilege Enables intrusion to gain access to an active CO/IP call.
Disable
Enable
Disable
Voice Over Enables use of Voice Over by the station.
Disable
Enable
Enable
Barge In Mode
Barge-in permits an authorized Station to intrude into other
existing outside/internal calls or to force disconnection existing
of an existing call.
Disable/
Only Monitor/
Monitor & Join &
Disconnect
Disable
Camp on enable
Station can receive a Camp-on while busy. If Camp On Tone
is enabled, the stations receive Camp-on tone, otherwise only
the LCD will indicate the camp on call. If the station is not
allowed to receive a Camp-On, the calling user receives error
tone.
OFF
ON
ON
Video Show on
Calling (ex. IP
Video Door
Phone)
When VoIP video door phone rings to a video-enabled IPKTS
handset, the video streaming commences immediately while
the IPKTS handset is in the ringing and the video stream
continues when answered.
- OFF : normal implementation (video starts after answer)
- ON: video stream from this Video Door Phone to the ringing
video-enabled LIP Phone even though this is alerting stage.
- Condition: A VOIU/VOIB channel for RTP-Packet-Relay
purpose is required to serve ring-back-tone generation via a
DSP channel.
That is because system does pre-answer to the Video Door
Phone even though the receiving station is on alerting state.
OFF
ON
OFF

Table of Contents

Other manuals for iPECS UCP

Related product manuals