iPECS UCP - 2.73 Speed Dial; 2.73.1 Display Security

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
189
Table 3.3.9.12-1 MOBILE EXTENSION (PGM 236)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
4
100 : TEL NUMBER
………………………..
Telephone number of the Mobile
extension.
Not assigned
5
TABLE 001 CLI
………………………
When the mobile Telephone
number and CLI do not match, the
CLI entered here is used to
authorize incoming calls from the
mobile.
Not assigned
6
100 : HUNT CALL ENABLE
(1:ON/0:OFF) : OFF
When the paired station is a
member of a hunt group (ACD,
Circular or Terminal), group calls
can be sent to the active mobile
extension.
0: OFF
1: ON
OFF
7
100 : VSF NOTIFY
(1:ON/0:OFF) : OFF
Enables outbound notification by
the system when the VSF has
unheard messages.
0: OFF
1: ON
OFF
8
100 : NOTIFY RETRY CNT
(1~9) : 3
Defines the number of attempts the
system will make to complete a
notification when receiving busy/no-
answer.
1~9 3
9
100 : NOTIFY RETRY INT
(1~3) : 3
Defines the time between
notification attempts. If a notification
fails, the system will retry after the
timer expires.
1~3
(Minutes)
3
10
100 : NOTIFY BY MY CLI
(1:ON/0:OFF) : OFF
When the system sends CLI to the
mobile extension, the CLI can be
either the original caller’s CLI or the
CLI of station.
0: OFF
1: ON
OFF
11
100 : CALL BACK
(1:ON/0:OFF) : OFF
If it is set to “ON”, incoming mobile
extension call will be released
before answered and system places
a call to mobile extension. After
mobile extension answers, the dial
tone is provided and mobile
extension can make internal or
external call.
0: OFF
1: ON
OFF
12
100 : DELAY TIMER
(000-255) : 000
Mobile extension call will be placed
after delay time.
000~255 0
13
100 : ANNOUNCE
(00-200) : 00
It can be announced for remote
control.
0~200 0
14
100 : SUFFIX DID TBL T
(1:ON/0:OFF) : OFF
It provide flexible DID table index
when DID type 2 is used.
0: OFF
1: ON
OFF