iPECS UCP - 2.75 Station Groups

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
198
Table 3.3.10.4-1 NETWORK NUMBERING PLAN (PGM 324)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
9
001 NET PSTN ENBLOCK
(0:NO/1:YES) : NO
Choose “Transit-out Public Line”
to En-block or Over-lap.
0: NO
1: YES
NO
10
001 CO ATD CODE CLI
(1:ON/0:OFF) : OFF
Determine whether if Centralized
ATD CLI is sent or not when slave
system makes transit call.
0: OFF
1: ON
OFF
11
001 FIREWALL ROUTING
(1:ON/0:OFF) : ON
Select IP address (Firewall IP
address or Non-firewall IP
address).
If the destination system (VOIB) is
in same VPN then Non-firewall IP
address should be sent.
Otherwise the firewall IP address
should be sent.
ON : Send firewall IP address
OFF : Send Non-firewall (Internal)
IP address
0: OFF
1: ON
ON
12
001 AUTHO CODE COS USE
(0:NO/1:YES): NO
When there‘s a transit out call
request from user of slave system
by seizing CO line, apply COS
according to the authorization
code.
0: NO
1: YES
NO
13
001 SMDR DIAL HIDDEN
(0:NO/1:YES): NO
Determine to display dialed digit of
transit out call or not at the slave
system; it can contain
authorization code.
0: NO
1: YES
NO
14
001 NET PSTN CLI
(0:NET/1:PSTN): NET
NET: Send network station
number for CLI PSTN: Send full
CLI (e.g., 02-450-1000)
0: NET
1: PSTN
NET
15
001 SITE NAME
.............
It is comment field to set name of
network site.
Max. 12 characters
16
001 EMERGENCY RERTE
TMR
(00-10) : 00
When timer is ‘0’: The reroute
emergency call is not work. When
timer is set ‘1’~’10’: The reroute
emergency call is activated after
this timer. This is only work when
PGM 112-18
th is transit-out CO
group.
00-10 00