iPECS UCP - Page 22

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
7
Table 2.1-3 UCP System Capacities
ITEM
UCP100
UCP600
UCP2400
Remark
(Groups)
Station Speed Dial, per Station
100
Total Station Speed Dial
24,000
Call park
200
Last Number Redial
10 (23 digits)
Save Number Redial
1 (23 digits)
Standard DSS Consoles/Station
9
Serial DSS - System
500
Serial DSS - Station (LIP-8000)
4
Serial DSS – Station (LIP-9000)
1
SMDR buffer
30,000
CO Line Groups
200
Station & Station Groups
200
Station & Station Group Members
200
Pickup Groups
200
Pickup Group Member
2,4000
Personal Groups
1200
Conference Group - System
160
Conference Group - Station
100
Executive/Secretary pairs
100
Authorization Codes
5200 (Station:2400/System:2800)
Transparent Networking Table
100
CLI Msg Wait (Missed calls)
4,000
Redundancy
N/A Yes
Flex DID Table
10,000
MSN table
2,400
DID Digits Analysis
4
Tenancy (ICM) Groups
100
ICLID table
500
NOTE
1. iPECS UCP-100 is equipped with two (2) FXS ports, and one of several built-in CO
Line units may be factory or field installed.
4 analog CO Lines (UCP-COIU4), uses two (2) VoIP DSP channels
2 BRI Lines, 2B+D each, (UCP-BRIU2) , uses two (2) VoIP DSP channels
4 BRI Lines, each 2B+D, (UCP-BRIU4) , uses four (4) VoIP DSP channels
Note the built-in PSTN interfaces require dedicated DSP resources. These DSP
resources reduce the maximum VoIP DSP resources available shown in the above
chart.
2. The built-in VoIP Switching channels implement agent and packet relay functions.
Remote device and network interfaces send RTP traffic to the VoIP channel, which
forwards traffic to the appropriate local iPECS device. The VoIP Switching channel
also forwards multi-cast packets to the remote end-points and local non-iPECS
devices. Only the g.711 codec is allowed unless there is an available VoIP DSP
channel.