iPECS UCP - 2.87.4 Zone Outgoing Call Connection Limit

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
266
Table 4.4.2.2-1 Common Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Except CO
to CO
Individual CO
Access
Permits stations to use dial codes to access individual CO/IP
Lines.
Disable
Enable
Enable
CO/IP Line
Queuing
Permits the station to queue for the next available Line when
an All Lines Busy signal is received.
Disable
Enable
Enable
Ringing Line
Preference
Enables Ringing Line Preference for the station. Calls that ring
the telephone can be answered by going off-hook without
selecting the CO/IP Line button.
Disable
Enable
Enable
Speed Dial
Access
Allows the station to access System Speed Dial bins.
Disable
Enable
Enable
Alarm/Door Bell Assigns a station to receive Alarm/Door Bell signal.
Disable
Enable
Disable
Station Account
When ON, the station user must enter an authorization code
to access CO/IP Lines.
OFF
ON
OFF
Forced SMDR
Account Code
When On, the user must enter an Account code to place an
outgoing call.
OFF
ON
OFF
Loop LCR
Account
The Station may be required to enter a Station Authorization
code to access LOOP LCR operation.
OFF
ON
OFF
Door Open Enables use of Door open feature by station.
Disable
Enable
Enable
Flex Button PGM
The ability to assign Flexible buttons of the iPECS IP and LDP
Phones can be controlled. When allowed here, the user may
assign features to Flexible buttons but requires special
assignments to configure CO/IP Line buttons.
OFF
ON
ON
Prefer CO or
Group
The System will seize this CO/IP Line or a Line from the
CO/IP group number when the station dials “9” (First available
Co access code)
CO/IP Line/
CO Group
number
Access
code
Emergency CO or
Group
This field defines the CO/IP Line or Group employed by the
system to place Emergency Assistance calls.
CO # or CO
Group #
Any CO
ICM Tenancy
Group
Assigns stations to an ICM Tenancy Group.
eMG80:1~15
eMG800:0~32
UCP:0~100
1
Call Time
Restriction
All outgoing calls will disconnect at expiration of the Call
Restrict Timer. The Cut-Off Timers can be set the time for
Station and CO Line. For cut off timer of Station, refer to the
title “Station Timers (123)”. For CO line, refer to the title “CO
Line data: Common Attributes (144)”.
OFF
ON
OFF
Proctor Monitoring
Power-Fail
Enables use of PABX ANI Link device for E-911 support, Only
an SLT port can be used for this feature.
OFF
ON
OFF
Line Release Cost
Display
When a CO/IP line is released, the disconnect cause or call-
cost is displayed in the LCD of iPECS IP or LDP Phone.
OFF
ON
OFF
Active PTT Group
Number
A station can be assigned to a PTT (Push-to-Talk) group and
the group enabled so the station can place and receive PTT
announcements for the group.
0~9
Hot Desk Station
A station (only IP Phone) can be assigned as a Hot Desk
phone. Users and agents can login and use resources of the
system through the Hot Desk phone.
OFF
ON
OFF
SMDR Hidden
If this feature enables, the dialed digit can be hided on SMDR
Disable
Disable