iPECS UCP - 3.12 Push to Talk Paging

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
293
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Router IP Address
Set the Router IP address for a linked station.
IPv4 address
Mode
Display operating mode of the station, remote or local
and NAT or NAPT.
Remote:
-. R/NAPT
-. R/NAT
-. R/NAP
-. R
Local remote
-. LO/NAPT
-. LO/NAT
-. LO/NAP
-. LO Local
-. L/NAPT
-. L/NAT
-. L/NAP
-. L
L (Local)
ARP
If set OFF, the system will employ layer 2 switching over
the LAN to communicate with the linked station. If set
ON,
the system will employ ARP (Address Resolution
Protocol) to determine the IP address of the device, if
required, and communicate using IP.
OFF
ON
OFF
Register
Normally, iPECS IP devices register using multi-cast
packets. When separated from the system, that is when
the device is remote, unicast is used.
Multicast
Unicast
Multicast
Codec Type A specific Codec type can be configured for the station.
G.711/
G.723.1/
G.729/
System, use the
codec defined for
the system
G.711