iPECS UCP - Page 348

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
333
Table 4.4.4.10-1 NA ISDN LINE ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
SPID uniquely identifies a particular set of
subscription parameters assigned to a TSP.
Directory Number
Initializing terminals are required to store a 7-digit DN
in order to perform the compatibility checking
procedures that are part of call termination.
20 digits
EKTS Mode
The EKTS (Electronic Key Telephone Service)
terminal permits a user to operate those features that
are specific to EKTS, as well as voice features that
may function distinctly in the EKTS environment.
EKTS allows a DN to be shared by more than one
terminal, on the same or on different interfaces.
NONE/
EKTS
NONE
Type for 1/2/3
ISDN CALLED NO uses the International format,
National format, Network format, Subscriber format, or
Abbreviated format when the user dials 1~3digits.
Unknown/
International/
National/
Network/
Subscriber/
Abbreviated
Unknown
Type for 4/5/6
ISDN CALLED NO is constructed with International
format, National format, Network format, Subscriber
format, or Abbreviated format when the user dials 4~6
digits.
Unknown/
International/
National/
Network/
Subscriber/
Abbreviated
Unknown
Type for 7/8/9
ISDN CALLED NO is constructed with International
format, National format, Network format, Subscriber
format, or Abbreviated format when the user dials 7~9
digits.
Unknown/
International/
National/
Network/
Subscriber/
Abbreviated
Unknown
Type for 10/11
ISDN CALLED NO is constructed with International
format, National format, Network format, Subscriber
format, or Abbreviated format when the user dials
more than 10 digits.
Unknown/
International/
National/
Network/
Subscriber/
Abbreviated
Unknown