iPECS UCP - Page 439

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
424
Table 4.4.6.3-7 FEATURE SERVER VOICE MAIL GROUP ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
no announcement.
VSF Announce 2 Auto
Drop
If this attribute is selected, the call will drop after the 2nd
VSF announcement.
Check box
VSF Announce 2
Repeat Timer
The 2nd announcement can be repeated to calls that
remain in queue at intervals of the announcement 2
repeat timer. Note VSF Announce 2 Repeat below must
be “ON”.
000~999
(seconds)
000
VSF Announce 2
Repeat
After the 2nd announcement, if the call remains queued
to the group, the 2nd VSF announcement can be
repeated at the VSF Announce Repeat timer interval,
above.
OFF
ON
OFF
Overflow Destination
A call to the group will continue to route through the
group until answered or all group members have been
tried. The call will remain at the last station or route to the
assigned Overflow Destination. If assigned VSF
Announce, Auto Drop is available.
STA/NET or
Station group,
VSF
Announcement,
Auto drop,
System Speed
Overflow Timer
A call to a group will remain at the last station in the
group or route to the assigned Overflow Destination after
expiration of the Overflow Timer.
000~600
(seconds)
180
No Answer Timer
Calls to a station in the group are directed to the station,
if unavailable or unanswered in the No Answer Timer, the
call can be routed based on the assigned hunt process.
00~99
(seconds)
15
Pilot Station Group
A FS-VM Station group can be set so that only calls to
the pilot number (station group number) will hunt.
OFF
ON
ON
Alternate Destination
When a call comes into the group and there are no group
members available, the call will be routed to the assigned
Alternate Destination.
STA/NET or
Station group,
System SPD
Station Group type
The Station group process for the FS-VM group can be
defined as Circular or Terminal.
Circular/
Terminal
Circular
Wrap-Up Timer
After terminating any call, the FS port will be maintained
in a busy state for the duration of the Wrap-Up Timer.
000~999
(seconds)
2
Forced Forward
Destination
Calls to a group may forward directly to a defined
destination, by passing the hunt process. “Forced
Forward”, below, must be enabled.
Sta./NET or
Station group,
VSF
announcement,
Sys. Speed
Forced Forward Dest
Usage
Calls to a Station group may forward directly to a defined
destination, see above “Forced Forward Destination”
when Forced Forward is enabled for the group.
OFF
ON
OFF
Group Name A group name can be designated.
Max. 12
characters