iPECS UCP - Page 494

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
479
Table 4.4.9.1-1 LCR Control Attribute
ATTRIBUTE DESCRIPTION RANGE DEFAULT
LCR Access Mode
This entry defines the effective LCR modes, the modes
by which the user can access LCR.
Disable/
Only Loop LCR/
Internal and Loop
LCR/
Loop and Direct
CO LCR/
Internal, Loop and
Direct CO LCR/
Internal, Loop,
Direct CO and
Direct Loop LCR
Disable
Day Zone
Each day of the week is assigned to a Day Zone (1~3).
The active Day Zone is the Zone assigned to the
current day of the week.
Zone1~3
(days of the
week)
Zone 1
Time Zone1
This entry defines the hours of the day during which
each Zone is active for Time Zone 1. Note hours not
defined in Time Zone 2 and 3 are automatically part of
Time Zone 1.
00~24 00~24
Time Zone2
This entry defines the hours of the day during which
each Zone 2 is active for Time Zone 2. Note hours not
defined in Time Zone 2 and 3 are automatically part of
Time Zone 1.
00~24 00~24
Time Zone3
This entry defines the hours of the day during which
Zone 3 is active for Time Zone 3. Note hours not
defined in Time Zone 2 and 3 are automatically part of
Time Zone 1.
00~24 00~24