iPECS UCP - Page 498

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
483
Table 4.4.9.3-1 LCR DIGIT MODIFICATION
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Add Digits
This entry defines the digit stream to insert in the number
after digit removal. Digits 0~9, ‛*‘, ‛#‘, and special
characters,
P: timed Pause
D: Dial tone detect
F: Billing station number
Max. 25 digits
Removal Position
This entry defines the position of the digit where removal
is to begin, starting with the 1st dialed digit (01).
01~12 1
Number of digits to
be removed
This entry defines the number of digits to remove starting
at the “Removal Position
00~12 0
Add Position
This entry defines the position in the number, after digit
removal, where the Add Digits are inserted.
01~13 1
CO/IP Group
This entry defines the CO/IP Group that the system will
attempt to use for the call.
eMG80:01-21
eMG800:01-202
UCP: 01-201
1
Alternative DMT
Index
This entry defines an Alternate Digit Modification Table
Index to use if no path is available in the assigned CO/IP
Group.
00~99
Networking
Number Plan Bin
This entry defines the Net Number Plan Table bin that
the system will attempt to use for the transit out call.
001-251
SMDR Code
This only used for TNET with CM. This code will be send
to CM when the TNET status is changed from Local
survival mode to bypass mode.
Max. 4 digits
(Include * and #)