iPECS UCP - Page 520

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
505
Table 4.4.9.17-1 MOBILE EXTENSION TABLE
ATTRIBUTE DESCRIPTION RANGE DEFAULT
answer is defined.
Retry Interval
This field defines the time between notification
attempts. If a notification fails, the system will retry
after the timer expires.
1 – 3 minutes 3 Minute
Notify CLI
When the system sends CLI to the Mobile Extension,
the CLI can be either the original caller’s CLI or the
CLI of the station.
Caller
My Ext.
Caller
Call Back
If “ON”, an incoming Mobile Extension call will be
released before answered and system places a call
to Mobile Extension. After the Mobile answers, the
dial tone is provided and the Mobile Extension can
place internal or external calls.
OFF
ON
OFF
Delay Timer
When the Mobile Extension requests a Call Back, the
system will place the Call Back after expiration of this
Delay timer.
0 ~ 255 0
Announcement
A system announcement can be recorded to provide
the Mobile caller with a menu of dialing commands
available to the remote Mobile user, remote control.
0-200 0
CO Group
The CO/IP Line group used to call (ring) the Mobile
Extension is defined.
eMG80:1~21
eMG800:1~201
UCP: 1~201
1
Telephone Number
The telephone number of the Mobile extension or
Fail-over number of the station must be assigned for
proper operation.
Not assigned
CLI Number
When the Mobile Telephone number and CLI do not
match, the CLI entered here is used to authorize
incoming calls from the Mobile.
Not assigned
Suffix DID table index
to the CLI
An incoming DID call is passed to the Mobile
Extension with the original caller’s CLI and the
Flexible DID Conversion Table index.
(format: ‘original CLI’ + ‘*’ + ‘DID Table Index’)
OFF/ON OFF
Tel Num As CLI Num
If this option is set to ON, Telephone Number is used
the same as CLI Number.
That means, when the mobile user calls to his
station, if Telephone Number or CLI Number is
matched with his mobile number, then the mobile
user hears system dial tone, and calling to outside is
available.
If this option is set to OFF, only CLI Number is
matched, system dial tone is served.
OFF/ON ON