iPECS UCP - Page 552

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
537
Table 4.4.13.3-1 DEVICE ZONE ATTRIBUTES
ATTRIBUTE DESCRIPTION RANGE DEFAULT
English as the LCD Display Language. dependent
Codec Type
The codec selection method can be defined as device
based, see PGM 132, or based on the codec type
assigned to the Zone.
Follow Zone,
Follow Me
(ADM132)
Follow Me
(ADM132)
RTP Relay Group
This attribute defines the RTP Relay group employed by
the device, 00-no relay. Zone parameters define the
VoIP device to employ.
00-15
00
(no relay)
Page Area Group
The Paging Area Group identity is employed to
determine when multicast to unicast conversion is
needed to relay paging data across the network using a
VoIP channel of a VOIU/VOIM or Paging Agent (VoIP
channel of an iPECS LIP Phone).
00-15
00
(same paging
relay area)
VM Device Slot
Sequence.
(VMIU/VMIB Slot
Sequence)
The VSF gateway used to support Voice Mail for a
device is defined. The VSF/UVM must be under control
of the same eMG/UCP as the device.
eMG80: Max. 3
Digits
eMG800/UCP:
Max. 4Digits
Select Default Multi
Language
The recorded language selection prompt is played to the
user when accessing the built-in AA/VM. The system
supports up to six languages.
1 ~ 6 1
VM Retry Count
The user may select an available language. If the
language is unavailable, the user may attempt to enter a
valid language type based on this retry counter. If the
user cannot enter a valid language, the announcement is
provided in the default language.
0-9 3
Remark
Descriptive information to help installer/programmer in
identifying the device Zone, i.e. Branch1.
Max. 21
characters