iPECS UCP - Page 89

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
74
Table 3.3.4.3-1 BOARD ATTRIBUTES (PGM 132)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
5
001-002 TNET ENABLE
(0:ON/0:OFF) : OFF
When a module or station is to
be connected in a Centralized
Control network (TNET), the
device must be enabled for
TNET operation.
0: OFF
1: ON
OFF
6
001-002 VSF SENDER MAIL
. . . . . . . . . . . .
VMIU/VMIB e-mail address for
Mailbox Mail Sending.
NULL
7
001-002 T38 ENABLE
(1:ON/0:OFF) : OFF
T38 mode ON/OFF for FAX data
transfer.
0: OFF
1: ON
OFF
8
001-002 USE BRD IP FWIP
(1:ON/0:OFF) : OFF
VOIB IP will be used for SIP
signaling in Multi NAT
circumstance.
0: OFF
1: ON
OFF
9
001-002 RTP FIRWALL IP
0 .0 .0 .0
Enter the Firewall IP address
associated with the Remote Phone
or Gateway/board if there needs
Dual Broadband connection for SIP
trunks and Remote phones (using a
VOIB).
0.0.0.0
10
001-002 T38 PORT USAGE
(0:D/1:S/2:T) : 0
T38 Port can be different with
Voice Port. Or, be same or be
triggered.
0: D
1: S
2: T
0
11
001-002 2833 PAYLOAD
(000-127) : 000
RFC 2833 Payload is
programmable.
000-127 000
12
001-002 2833 VOLUME
(00-36) : 00
RFC 2833 packet volume. 00-36 00
13
001-002 2833 REDUNDANCY
(1-8) : 0
RFC2833 Packet Redundancy. 1-8 0