iPECS UCP - 2.35 Door Open

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
99
Table 3.3.6.1-1 SYSTEM ATTRIBUTES I (PGM 160)
BTN ATTRIBUTE/DISPLAY DESCRIPTION RANGE DEFAULT
6
EXTERNAL NIGHT RING
(1 : ON/ 0 : OFF) : OFF
CO/IP calls, which are assigned
UNA, can activate the Loud Bell
Contact. An incoming call, received
while in Night, will activate the
contact.
0: OFF
1: ON
OFF
7
HOLD PREFERENCE
(1: SYS/ 0: EXC) : SYS
A single depression of the [HOLD]
button places the call on the
preferred hold, System or
Exclusive.
0: Excl
1: System
System
8
PRINT LCR CONV DIGIT
(1 : LCR/ 0 : USER) : LCR
SMDR will output the number dialed
by either the system’s LCR or the
user.
0: User
1: LCR
LCR
9
ATD CALL QUE AVAILABLE
(1:ON/0:OFF) : OFF
The system can be configured to
queue incoming calls to a busy
Attendant.
0: OFF
1: ON
OFF
10
USE PGM_0 IN ALL ATTD
(1 : ON/ 0 : OFF) : OFF
This field allows Main attendants
access to all Attendant functions
including System Attendant features
and programming.
(Except PGM 06 – Record system
announcement)
0: OFF
1: ON
OFF
11
OFFNET PROMPT USAGE
(1 : ON/ 0 : OFF) : OFF
When a call is routed to a
destination external to the iPECS,
the Off Net routing prompt can be
played. Not available in US version.
0: OFF
1: ON
OFF
12
CO-TO-CO UC TMR EXTEND
(1:ON/0:OFF) : OFF
When an Unsupervised Conference
is established with DISA, Off-Net
Fwd, etc., the Unsupervised
Conference timer (PGM 182-button
5 determines the allowed duration
of the call. If enabled here, the user
may dial ‘#’ to extend the allowed
duration.
0: OFF
1: ON
OFF
13
ACD MANAGER PRINT
(1:ON/0:OFF) : OFF
When the optional ACD Message
events are desired, the system
must be enabled to send ACD
event messages.
0: OFF
1: ON
OFF
14
CALL LOG LIST NUM
(15-50) : 15
The Call Log that saves the
Outgoing call, Received call, or Lost
call information can be displayed by
pressing Call Log Display Button.
The maximum size of the Call Log
per station is defined here.
15~50 15
15
REPEAT DTMF TONE
(1:ON/0:OFF) : OFF
When enabled, the system will
provide DTMF repeat tone to the
caller’s station. It’s nothing to do
with PSTN.
0: OFF
1: ON
OFF