iPECS UCP - 3. INTERCOM; 3.1 Barge-In

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
268
Table 4.4.2.2-1 Common Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
ON”.
If Lift Handset for Page is OFF, then User can make page on
speakerphone without lift handset.
Privacy
If Privacy is ON, then any person could not barge-in to the
station and also Attendant can’t intrude to Station. Also, if
Privacy is ON, any person can’t forcefully disconnect the
station.
OFF
ON
OFF
Call Coverage Attributes
Call Coverage
Mode
The Call Coverage feature permits an iPECS IP or LDP
Phone user to receive ring and answer calls for other stations.
OFF
ON
OFF
Call Coverage
Delay Ring
When a covered station rings, the {CALL COVERAGE}
button LED will flash at the covering station and the station will
receive ring (immediate or delayed by 0 to 15 ring cycles).
0~15 0
Call Coverage On
Busy
OFF: Call Coverage is implemented when a covered station is
in the idle state.
ON: Call Coverage is implemented when a covered station is
on idle or busy state.
OFF
ON
ON
Call Coverage
Through Mobile
Extension
OFF: Call Coverage Ring is not delivered to Mobile Extension
ON: Call Coverage Ring is not delivered to Mobile Extension
OFF
ON
ON
Call Coverage On
Busy Range
External Call Only: Call Coverage only for external calls when
the covered station is busy
External and Internal Call: Call Coverage both for external &
internal calls when the covered station is busy
External Call
Only/
External and
Internal Call
External
Call
Only
Call Coverage
Delay Ring
Method
by Originator: Call Coverage Delay is implemented by the
covered station’s “Call Cover Delay Ring” delay count’
by Member: Call Coverage Delay is implemented by covering
station’s “Call Cover Delay Ring” delay count’
by Originator/
by Member
by
Originator
Call Coverage For
Wakeup Ring
OFF: Wakeup Ring to covered station is not covered
ON: Wakeup Ring to covered station is covered
OFF
ON
OFF
Call Coverage
Ring Type on
Member
Silence: No audible ring is presented and the user must press
the flashing Call Coverage button to answer the call.
Normal Ring: Audible ring is presented and the call can be
answered by simply lifting the handset or pressing the
Speaker button.
Mute ring is only supported in LIP-8000E series.
Silence/
Normal Ring/
Muted(Continuo
us)-80XXE only/
Muted(One
Burst)-80XXE
only
Normal
Ring
Tone/Ring Attributes
Call Time Tone
A tone can be sent periodically with indicating the elapsed
time of an outgoing CO/IP call. The Elapsed Call Timer
determines the period between tones. For more information
about Elapsed Call timer, refer to the title “System data:
System timer (180~182, 186)”.
OFF
ON
OFF
Camp-on Tone
When the Camp-on feature is enabled for the station, if the
station is busy and receives a Camp-on request, the LCD
indicates the camped on call. In addition, if Camp-on tone is
enabled, the Camp-On tone is sent to the station as an
audible signal for the camp-on.
OFF
ON
ON
ICM Dial Tone
One of four dial tone sources can be selected for each station.
Dial Tone/
Dial Tone