iPECS UCP - 3.2 Direct Station Selection;Busy Lamp Field (DSS;BLF)

iPECS eMG80 & eMG800 & UCP
Administration and Programming Manual Issue 1.6
269
Table 4.4.2.2-1 Common Attributes
ATTRIBUTE DESCRIPTION RANGE DEFAULT
Source Internal music/
External music/
VSF MOH/
SLT MOH1~5/
VSF MOH2/
VSF MOH3
ICM Ring Back
Tone Source
One of four ring back tones can be selected for each station.
Ring Back Tone/
Internal music/
External music/
VSF MOH/
SLT MOH1~5/
VSF MOH2~3
Ring Back
Tone
Off hook ring type
While the station is Off hook ring, the type of ring can be
adjusted as a single burst, muted normal ring, system ring or
no audible ring signal.
BURST/
MUTE/
Refer to System
Attributes
SILENCE
Refer to
System
attributes
SIP color ring
With a SIP based AA/VM that supports color ring, color ring
may be provided to SIP pones. The group number associated
with the external AA/VM should be entered as the SIP Color
Ring source.
Station
number
Gain table index
Selects one of three Tables employ to set the gain from a
device to other device types. PGM 410 to 417 under the
Maintenance tab set the individual gains.
1-3 1
Tone table index
Selects one of five Tables to determine the tones sent to the
Station. The individual tones are configured in PGM 410 to
417 under the Maintenance.
1-5 1
Digit conversion
table
One of the Digit Conversion Tables can be configured for use
for this CO/IP Line.
eMG80:1-15
eMG800:1-32
UCP: 1-32
Routing Attributes
Call Forward When allowed, Call Forward can be activated by the station.
OFF
ON
OFF
DND
Enables DND to be activated by the station. The station can
be limited to activate DND for outside calls (CO/IP Only) or for
internal calls (ICM only), if desired.
OFF/
ALL/
ICM call only/
CO call only
OFF
Off-net Forward
A station must be allowed Off-Net Fwd to forward external
incoming calls outside the system or otherwise establish a
CO-to-CO connection (Unsupervised Conference). (Except
USA version)
Disable
Enable
Enable
ACD Group
Service
When unavailable, DID/DISA calls to the station can route to
the ACD Group to which the station is a member.
OFF
ON
OFF
Ring Group
Service
When unavailable, DID/DISA calls to the station can route to
the Ring Group to which the station is a member.
OFF
ON
OFF
ACD Login Priority
ACD Group members may be assigned a priority, 0-9.
Members with the highest priority are sent calls ahead of
lower priority members. This field is the same as PGM 191-
button 19.
0 ~ 9 0